RIM TAPE: 5 SIMPLE STEPS FOR SUCCESSFUL INSTALLATION!
CIRCULAR™ rim stripes: 5 steps to successful installation
It seems that some bikers are reluctant to fit their bikes with rim stripes because they think it's not easy to install, or they've had bad experiences with poor quality stickers.
You know how important quality and ease of use are to us. Our mission is to make visibility accessible to ever more motorcyclists, and it is for this reason that we develop quality, aesthetic and PRACTICAL products!
Wondering how best to install your rim stripes? Are you hesitating to take the plunge because it seems complicated? We explain everything to you in detail. Follow the guide !
1 - Prepare your bike
First, you will need to immobilize your motorcycle in a well-lit place where the temperature is at least 15°C. Remove the stickers already present from your wheels: the edging will hold much better and longer on a smooth surface.
For all those who have not read our article explaining how to winterize their motorcycle and who have not cleaned their motorcycle at the start of winter, don't panic, everything is still possible.
2 - Clean your rims
Obviously, you will have to clean your rims using a mild, non-oily detergent: the product used must not leave a film as this would prevent the edging from adhering properly. Dry the rim thoroughly with a clean, dry cloth.
3 - Glue your first edging
Peel off a first strip and place one end on the flat surface of the rim. Do not hesitate to press firmly on the edging in order to make it stick well to your rim. Note, however, that adhesion will be complete approximately 48 hours after installation. Gently remove the transfer film by pulling parallel to the surface and being careful that the product does not come off. Do the same with the other bands until you have completely gone around the rim.
Carefully cut the remaining part of the last strip using a pair of scissors or a box cutter.
4 - Chase the air bubbles
In order to drive out all the air bubbles, do not hesitate to smooth the tape along your rim.
Repeat the operation on your 4 rims and you are ready to go with your new Circular™ rim stripes.
5 - Test (and admire their incredible effect)!
Before hitting the road, stand at least one meter away from your motorcycle. Take a photo without flash then one with flash with your smartphone, you will see the effect immediately!
Bluffed? We understand you, it always happens the first time ;-)
Don't forget to share this with your favorite bikers!
Prefer a video tutorial?
The whole VFLUO team is mobilizing to make your life easier!
We have produced an explanatory video to show you the installation of your rim stripes.
